How to use the online timer
On the second run, you are rinsing the other muddy boot while the countdown moves through two minutes and two seconds. After a wet moorland walk, that repeat can keep each boot under the outdoor tap for roughly the same spell, while you turn it to reach the tread, welt and patches of clinging peat.
With the first boot beside you, the second rinse reveals whether the setting suits the mud rather than merely matching a fixed routine. The duration can be changed directly on the page: add time when thick clay remains between the lugs, or shorten it when rain has already loosened the dirt. A repeat is useful as a comparison, but the visible result should determine the setting.
As the second boot clears, spend the closing moments checking the grooves rather than continuing to spray an already clean upper. Deep tread may need most of the interval, whereas a smoother sole can finish earlier. If mud remains when the signal arrives, treat that as information for the next boot or pair: extend the setting slightly. If the water runs clear sooner, reduce it, so the task shapes the duration instead of forcing the rinse to fill every remaining second.
Common questions
What could make the same interval too short for rinsing boots after a UK moorland walk?
Sticky peat or clay packed into deep tread can take longer to loosen, especially after a wet walk. Extend the setting slightly if dirt is still lodged in the grooves when the signal sounds.
What if the second muddy boot is clean before the set time ends?
Stop rinsing once the water runs clear and note how much time remained. A shorter setting may suit the next boot if its tread and level of mud are similar.
Cookie policy