How to use the online timer
Running the countdown a second time gives you another eighty-one seconds to rinse the mud still clinging to your boots after a walk across the moor. While the water runs, work around the welt, tread and lace hooks rather than repeating the quick wash you have already done. The extra pass suits the dark, sticky ground often carried home from a wet British footpath.
Keep rinsing even if the timer tab slips behind a message, map or weather page. A background tab may stop showing each change smoothly, although the countdown should still measure the elapsed time; whether you hear its alert can depend on browser permissions and your phone’s sound settings. If the screen has locked, check the tab before assuming the second run is still visible.
Use the signal as the point to stop chasing every last speck of mud, then leave a small buffer before your next job. That spare moment is enough to turn off the tap, shake loose water outdoors and place the boots somewhere suitable to drain. If a deep tread still holds grit, note that section for a brief final rinse instead of letting the whole task consume the gap before you need to leave.
Common questions
What if wet moorland clay is still packed into the boots when the second countdown ends?
Dense clay can need longer than loose grit, especially inside deep walking-boot treads. Use the remaining gap before your next task only on the packed areas, then leave the boots to drain.
What should I do if the boots are clean before this second interval finishes?
Stop the water early and use the unused time to shake off droplets and clear mud from the sink or outdoor tap area. There is no benefit in continuing to rinse already clean material.
Cookie policy